• 家图标
  • 箭头图标 产品
  • 箭头图标Low Power 收发器 with 以太网 - VHF / UHF (20-90)

Low Power 收发器 with 以太网 - VHF / UHF

20-90

The 20-90 is a simple to configure POCSAG paging transceiver with a high sensitivity receiver combined with a 100mW transmitter. It operates over the frequency range of 142-175MHz (VHF variant) or 440 479MHz (UHF variant) decoding and encoding 512, 1200或2400波特, alphanumeric or numeric messages.

The 20-90 supports multiple message queueing and will queue up to four 73-character messages or more smaller messages.

 

The 20-90 Can be controlled via an RS232 serial interface or TCP/IP to provide numeric, alphanumeric and tone only POCSAG encoding.

The product supports full batching of serially queued input messages and can be configured to automatically respond with checksum information of the last received message.

An intelligent self-adjusting channel busy check prevents message collision or corruption.

The receiver is supplied with clean contacts rated at 1A 24V DC operation. LEDs indicate receiver operation and status.

Virtual outputs can be used to remotely trigger input or periodic messages and provide a mechanism to acknowledge reception of messages. It can transmit the received signal strength of the last received message allowing the receiver positioning and system health to be monitored.

  • Supports Salcom relay control protocol to control one on-board relay plus several “virtual outputs”
  • TCP / IP连接
  • Virtual outputs can be used to remotely trigger input or periodic messages
  • 5 user definable I/O configurable as input or outputs
  • 2 dedicated clean-contact relay outputs
  • FSK与NRZ数据
  • 142 - 175 mhz(甚高频) & 440-479 MHz (UHF) variants available
  • 输出功率高达100mW
  • 十大网堵平台 收发器: allowing both the encoding and decoding of paging messages
  • 十大网堵平台 接收机 (only—by configuration): allowing the decoding (only) of paging messages where desired
  • 发射机: With channel busy check function before transmissions
  • 自动存储 & Forward 十大网堵平台 中继器 with duplicate message reject
  • Allows TCP/IP output for closed loop system monitoring of messages received
Technical 规范
频率范围 甚高频:140 - 176MHz
UHF: 420 - 480MHz
频率选择 用户可配置的
传输能量 10mW, 20mW, 50mW or 100mW
发射占空比 100%
通道宽度 6.25khz, 12.5千赫或25千赫
偏差 ±1.0 khz,±2.3kHz或±4.5 khz
调制 GFSK with NRZ data (POCSAG)
空中波特率 512, 1200, 2400
接收机灵敏度 - 123dbm, 512波特
- 118dbm, 2400波特
继电器 Two 继电器 on RJ45 connector; one SPDT, one SPST
可定义I / O Five I/O pins user configurable as input or output
明渠输出 Up to two 500mA open drain outputs with resettable fuses on RJ45
Up to three 5mA current limited open drain outputs on RJ12
输入 Up to five active low inputs on open drain output pins
串行端口 RS-232 on RJ12 connector. 9600 baud, no parity, 8-bits, 1-stopbit
数据接口 RS-232 (with adaptor) and 以太网
串行协议 Salcom, Scope, TNPP v3.8
配置软件 Salcom 配置工具 (Sacoto)
射频连接器 50ΩSMA
电源连接器 DC power pluggable terminal block (provided)
电力供应 +13.8V typical (10 to 15 VDC range)
电力消耗 马备用:45
传输:90马
以太网: +35mA when connected to 以太网
继电器: +20mA per energized relay
工作温度 -10ºC to +50ºC (+14ºF to +122ºF)
Environmental Protection Not suitable for unprotected outdoor use. Must be protected from adverse
environmental conditions.
指标 电源指示灯(绿色)
• Slow Flashing = Normal Operation
• Fast Flashing = low battery
TX/Busy LED(红色)
• Flashing fast = Transmitting
• Solid on = Chanel busy
重量 190g
外壳尺寸 130mm x 68mm x 31mm (W x D x H)
外壳材料 挤压铝
颜色 Bright silver anodised aluminium
类型的审批 通过4769.1:2000 + Amendment 1:2002 (RF)
En 300-224 v2.1.0 (RF), EN 301-489-2 V2.1.0 (EMC)
EN 60950-1:2006 (Safety)
FCC CFR47 Part 90 (RF), Part 2 (RF), Part 15 (EMC), Part 1 (Safety)
20 - 90小册子
Sacoto v1.1.7. 配置工具
20-90产品手册
  • 信息

    The 20-90 Can be controlled via an RS232 serial interface or TCP/IP to provide numeric, alphanumeric and tone only POCSAG encoding.

    The product supports full batching of serially queued input messages and can be configured to automatically respond with checksum information of the last received message.

    An intelligent self-adjusting channel busy check prevents message collision or corruption.

    The receiver is supplied with clean contacts rated at 1A 24V DC operation. LEDs indicate receiver operation and status.

    Virtual outputs can be used to remotely trigger input or periodic messages and provide a mechanism to acknowledge reception of messages. It can transmit the received signal strength of the last received message allowing the receiver positioning and system health to be monitored.

  • Details
    • Supports Salcom relay control protocol to control one on-board relay plus several “virtual outputs”
    • TCP / IP连接
    • Virtual outputs can be used to remotely trigger input or periodic messages
    • 5 user definable I/O configurable as input or outputs
    • 2 dedicated clean-contact relay outputs
    • FSK与NRZ数据
    • 142 - 175 mhz(甚高频) & 440-479 MHz (UHF) variants available
    • 输出功率高达100mW
    • 十大网堵平台 收发器: allowing both the encoding and decoding of paging messages
    • 十大网堵平台 接收机 (only—by configuration): allowing the decoding (only) of paging messages where desired
    • 发射机: With channel busy check function before transmissions
    • 自动存储 & Forward 十大网堵平台 中继器 with duplicate message reject
    • Allows TCP/IP output for closed loop system monitoring of messages received
  • 规范
    Technical 规范
    频率范围 甚高频:140 - 176MHz
    UHF: 420 - 480MHz
    频率选择 用户可配置的
    传输能量 10mW, 20mW, 50mW or 100mW
    发射占空比 100%
    通道宽度 6.25khz, 12.5千赫或25千赫
    偏差 ±1.0 khz,±2.3kHz或±4.5 khz
    调制 GFSK with NRZ data (POCSAG)
    空中波特率 512, 1200, 2400
    接收机灵敏度 - 123dbm, 512波特
    - 118dbm, 2400波特
    继电器 Two 继电器 on RJ45 connector; one SPDT, one SPST
    可定义I / O Five I/O pins user configurable as input or output
    明渠输出 Up to two 500mA open drain outputs with resettable fuses on RJ45
    Up to three 5mA current limited open drain outputs on RJ12
    输入 Up to five active low inputs on open drain output pins
    串行端口 RS-232 on RJ12 connector. 9600 baud, no parity, 8-bits, 1-stopbit
    数据接口 RS-232 (with adaptor) and 以太网
    串行协议 Salcom, Scope, TNPP v3.8
    配置软件 Salcom 配置工具 (Sacoto)
    射频连接器 50ΩSMA
    电源连接器 DC power pluggable terminal block (provided)
    电力供应 +13.8V typical (10 to 15 VDC range)
    电力消耗 马备用:45
    传输:90马
    以太网: +35mA when connected to 以太网
    继电器: +20mA per energized relay
    工作温度 -10ºC to +50ºC (+14ºF to +122ºF)
    Environmental Protection Not suitable for unprotected outdoor use. Must be protected from adverse
    environmental conditions.
    指标 电源指示灯(绿色)
    • Slow Flashing = Normal Operation
    • Fast Flashing = low battery
    TX/Busy LED(红色)
    • Flashing fast = Transmitting
    • Solid on = Chanel busy
    重量 190g
    外壳尺寸 130mm x 68mm x 31mm (W x D x H)
    外壳材料 挤压铝
    颜色 Bright silver anodised aluminium
    类型的审批 通过4769.1:2000 + Amendment 1:2002 (RF)
    En 300-224 v2.1.0 (RF), EN 301-489-2 V2.1.0 (EMC)
    EN 60950-1:2006 (Safety)
    FCC CFR47 Part 90 (RF), Part 2 (RF), Part 15 (EMC), Part 1 (Safety)
  • 手册 & 下载
    20 - 90小册子
    Sacoto v1.1.7. 配置工具
    20-90产品手册